User Manual of A90 Series Inverter modification, press the ENTER key ENTER to confirm and save the parameters and enable next user-defined parameter. Function code modifications in the Level 3 menus under different menu modes have equivalent effects. 4.2.3 Non-default mode ( -- C -- ) In the non-default mode, press the ENTER key to enter the Level 2 menu. The first parameter different from the default settings of the inverter will be displayed, starting from F00.00. When the right shift key is pressed in the Level 2 menu, the cursor will not shift.
If the increment or decrement key on the keyboard is pressed, the function group and function code will not be modified, and the non-default function code following and in front of the current function code will be displayed respectively. If the displayed function code is modifiable currently in the Level 3 menu, the lowest bit indicated by the cursor will flicker. In this case, parameters can be modified in the Level 3 menu under the full menu mode. After modification, press the ENTER key to confirm and save the parameters and enable next non-default parameter. For example, first change F00.03 to 1 and F00.07 to 40.00 in the full menu mode, which are different from default settings.
When the first parameter in the non-default mode is enabled, F00.03 will be displayed. Press the increment key on the keyboard to enable F00.07 and the decrement key to return to F00.03, as shown below: Fig. 4-5 Function Code Modification in Non-default Mode 53