User Manual of A90 Series Inverter The table below provides the details of the function code table: 64 Function code F00.00 to F99.99: function code number Function code name Full name of the function code. “Reserved” means that the corresponding function code is temporarily reserved and has no practical meaning. Brief description of the function code. It is mainly divided into the following three types: The value of the integral function code represents the current parameter selection or meaning. Integral Parameter description The ones, tens, hundreds, thousands and tens of thousands represent one option or the current meaning of the function code.
Quantifier Each binary bit represents one option or the current meaning of the function code. Binary Metric units of the function code. The units and abbreviations are as follows: Hz Hertz kW Kilowatt us Microsecond kHz Kilohertz kWh Kilowatt-h our★ ms Millisecond % Percent★ MWh Megawatt hour s Second Unit V Volt mΩ Milliohm min min A Amp mH Millihenry h h rpm rpm °C °C m m ★: %: The benchmarks are different for physical quantities; kWh: Kilowatt hour, commonly known as the degree. Function code settings before delivery, or values after parameter restoration (F12.14=1). This is mainly described by the following three categories. Number (e.g. Refer to each power segment.
The function code is set to the current value by default. Default setting 50.00) Depending on The default setting of this function code varies based on the power segments. the motor type The default setting of this function code varies based on the power segments and batches. XXX Change attribute of the function code (permission and condition of change), as described below: Changeable in running: The current function code can be changed in any status. Attribute ● Non-changeable in running: The current function code can be changed except in the running status. ○