cisco — Configuring a System Name

Configuring a System Name Follow these steps to manually configure a system name: Procedure Administering the Device Configuring a System Name Command or Action Purpose Device> enable Step 2 configure terminal Example: Device# configure terminal Enters global configuration mode. Step 3 interface interface-id Example: Device(config)# interface gigabitethernet1/0/1 Enters global configuration mode. Step 4 [no] ntp disable Example: Device(config-if)# ntp disable Disables NTP packets from being received on the interface. Use the no form of this command to re-enable receipt of NTP packets on an interface. Step 5 end Example: Device(config-if)# end Returns to privileged EXEC mode.

Command or Action Purpose Step 1 enable Example: Device> enable Enables privileged EXEC mode. • Enter your password if prompted. Step 2 configure terminal Example: Device# configure terminal Enters global configuration mode. Administering the Device 20