cisco — Setting Up DNS

Administering the Device Setting Up DNS Command or Action Purpose Device> enable Step 2 configure terminal Example: Device# configure terminal Enters global configuration mode. Step 3 ip domain name name Example: Device(config)# ip domain name Cisco.com Defines a default domain name that the software uses to complete unqualified hostnames (names without a dotted-decimal domain name). Do not include the initial period that separates an unqualified name from the domain name.

At boot time, no domain name is configured; however, if the device configuration comes from a BOOTP or Dynamic Host Configuration Protocol (DHCP) server, then the default domain name might be set by the BOOTP or DHCP server (if the servers were configured with this information). Step 4 ip name-server server-address1 [server-address2 ... server-address6] Example: Device(config)# ip name-server 192.168.1.100 192.168.1.200 192.168.1.300 Specifies the address of one or more name servers to use for name and address resolution. You can specify up to six name servers. Separate each server address with a space. The first server specified is the primary server.

The device sends DNS queries to the primary server first. If that query fails, the backup servers are queried. Step 5 ip domain lookup [nsap | source-interface interface] Example: Device(config)# ip domain-lookup (Optional) Enables DNS-based hostname-to-address translation on your device. This feature is enabled by default. If your network devices require connectivity with devices in networks for which you do not control name assignment, you can dynamically assign device names that uniquely identify your devices by using the global Internet naming scheme (DNS). Step 6 end Example: Device(config)# end Returns to privileged EXEC mode. Administering the Device 22