cisco — Configuring MAC Address Change Notification Traps

Configuring MAC Address Change Notification Traps Follow these steps to configure the switch to send MAC address change notification traps to an NMS host: Procedure Administering the Device Configuring MAC Address Change Notification Traps Command or Action Purpose Step 3 mac address-table aging-time [0 | 10-1000000] [routed-mac | vlan vlan-id] Example: Device(config)# mac address-table aging-time 500 vlan 2 Sets the length of time that a dynamic entry remains in the MAC address table after the entry is used or updated. The range is 10 to 1000000 seconds. The default is 300. You can also enter 0, which disables aging. Static address entries are never aged or removed from the table.

vlan-id—Valid IDs are 1 to 4094. Step 4 end Example: Device(config)# end Returns to privileged EXEC mode. Step 5 show running-config Example: Device# show running-config Verifies your entries. Step 6 copy running-config startup-config Example: Device# copy running-config startup-config (Optional) Saves your entries in the configuration file. Command or Action Purpose Step 1 enable Example: Device> enable Enables privileged EXEC mode. • Enter your password if prompted. Step 2 configure terminal Example: Device# configure terminal Enters global configuration mode. Administering the Device 26