Procedure Administering the Device Adding and Removing Static Address Entries Command or Action Purpose Step 1 enable Example: Device> enable Enables privileged EXEC mode. • Enter your password if prompted. Step 2 configure terminal Example: Device# configure terminal Enters global configuration mode. Step 3 mac address-table static mac-addr vlan vlan-id interface interface-id Example: Device(config)# mac address-table static c2f3.220a.12f4 vlan 4 interface gigabitethernet 1/0/1 Adds a static address to the MAC address table. • mac-addr—Specifies the destination MAC unicast address to add to the address table.
Packets with this destination address received in the specified VLAN are forwarded to the specified interface. • vlan-id—Specifies the VLAN for which the packet with the specified MAC address is received. Valid VLAN IDs are 1 to 4094. • interface-id—Specifies the interface to which the received packet is forwarded. Valid interfaces include physical ports or port channels. For static multicast addresses, you can enter multiple interface IDs. For static unicast addresses, you can enter only one interface at a time, but you can enter the command multiple times with the same MAC address and VLAN ID. Step 4 show running-config Example: Device# show running-config Verifies your entries.
Step 5 copy running-config startup-config Example: Device# copy running-config startup-config (Optional) Saves your entries in the configuration file. Administering the Device 34