D ISARMING A SPLIT SYSTEM If you enter the premises when the system is armed, the buzzer will begin to beep (if programmed) with an intermittent tone to indicate that the entry period has begun. As long as this beeping continues, you can disarm (switch off) the system with your code without activating an alarm. You also must not enter other areas of the system during the beeping. If you do, a siren will sound and a full alarm condition may occur. The entry period (length of time of the beeping) is programmed by the installer. 1. Go to the keypad. The entry period starts as soon as you open the entrance door, or when you enter the entry zone.
You can switch off the system without activating the alarm as long as the beeping continues. Beep Beep The current day, date and time are displayed. An example is shown. TUE 23 APR 07.39 2. Press the key 0 and then enter your code. A ‘*’ appears in the display for every key you press. Use the 0 key to cancel an incorrect entry and to restart a new entry of the code. Enter Code 0 + code Enter Code **** In this example, area 1 is armed and area 2 disarmed. Area 1 Armed Area 2 Disarmed You have a few seconds to enter the number of the area you want to switch off. Enter Area No. 3. Enter the area number (in this example it is 1). 1 Disarm? 4.
Press the Accept key to confirm you want to switch off area 1. ! Area 1 Disarmed Finished? 5. Press the Accept key to confirm you have finished. ! Area 1 Disarmed Area 2 Disarmed 6. If you want to disarm or modify another area, enter its number. Enter Area No. If you are finished, do nothing. The standby display message will automatically appear after a few seconds. Steps 4 and 5 may be automated by the system. If so, you will not have to press the Accept key. TUE 23 APR 07.40 User Manual for CD72/95/15003 Page 15