U SING THE KEYPAD This chapter describes the alarm system keypad. T HE CD3008 KEYPAD The keys 0 - 9 These keys are used to enter your code. Always begin with zero (0) and then enter your code. After entering the code, you can carry out the operations assigned to it. The options assigned to a code can be adjusted by the installer or manager. " When you are in an option list, this key can be used to go backwards in the list. During arming you can exclude zones. See Special keys . # This key has several functions. When you are in an option list, you can use it to move forward through the list. The other options are listed under Special keys . ! This key is the Accept key.
It is used to confirm that the option shown in the display should be implemented. X This is the Reject key. It is used to indicate that the option shown has not been changed or that you want to exit the option list. Special keys The following key combinations can be programmed by the installer. They may not be active in your system. "# "# "# "# Pressing these keys simultaneously will activate a personnel attack alarm. A report can then be sent over the phone lines to the central station, and the bells and flashing light may be activated. ## ## ## ## 1 Press the ‘ # ' key twice to see which zones are still open. All the open zones are displayed or the message ‘ All Closed’ appears.
"" "" "" "" 1 Press the ‘ " ‘ key twice to see which zones are inhibited. All the inhibited zones are displayed or the message ‘ No Inhibits’ appears. 1 If the system is split you must indicate which system you want information about. Systems which are armed or have been triggered cannot be selected. User Manual for CD72/95/15003 Page 5