AH500 Hardware Manual 5.5.2.3 Transistor Output Circuit The AH500 series transistor outputs are equipped with the diodes which provide the counter-electromotive force protection. They can be used if they are not turned ON/OFF frequently and there are low-power inductive loads. If they are turned ON/OFF frequently and there are high-power inductive loads, they must be connected to noise suppression circuits to reduce the noise and prevent the overvoltage or the overheating from damaging the transistor output circuit. NPN/PNP transistor output circuit 5-42 ① Direct-current power supply ② Emergency stop ③ Fuse ④ The output terminals of a transistor module are open-collector output terminals.
If Y0.0/Y0.1 is a pulse train output terminal of a transistor module, the output current passing through its output pull-up resistor must be greater than 0.1 A to ensure that the transistor module operates normally. A relay or a solenoid valve is used as a DC load. A diode is connected in parallel to absorb the surge voltage which occurs when the load is OFF. NPN transistor output (sinking) UP Relay/Sol enoid valve + Y0.0 DC power supply D ZP D: 1N4001 diode PNP transistor output (sourcing) UP D + DC power supply Y0.0 Relay/Solen oid valve ZP D: 1N4001 diode