AH500 Module Manual 3. If the value in n exceeds the range, the operation error occurs, the instruction is not executed, SM0 is ON, and the error code in SR0 is 16#200B. 4. Due to the fact that the use of the instruction TO decreases the execution efficiency of the CPU module and that of the I/O module, users should use it less often. 5. The descriptions of the error codes: 9.4 Setting AH10EN-5A through ISPSoft This section introduces the setting of AH10EN-5A through ISPSoft. There are three configurations in ISPSoft. 1. Hardware configuration: Setting the basic parameters 2. Network configuration: Setting the Ether Link 3. Intelligent module configuration:
Setting the exclusive parameters Please refer to ISPSoft User Manual for more information about scanning a module, and opening HWCONFIG and NWCONFIG. 9.4.1 HWCONFIG─Network Parameters All network devices which will be connected to networks need Internet Protocol addresses (IP addresses). The IP addresses are like numbers, and are used to identify the identities of these network devices on the networks. Operation mode Users can select an operation mode of AH10EN-5A. They can assign a single IP address to AH10EN-5A and make AH10EN-5A support a switching hub, or they can assign two IP addresses to AH10EN-5A and make the two ports operate individually.
IP address assignment 9-14 Error code Description 16#2003 Please refer to point 1 and point 2 in the additional remark. 16#200B Please refer to point 3 in the additional remark. 16#1400 An error occurs when the data is accessed through the auxiliary processor. 16#1401 An error occurs when the data in the I/O module is accessed. 16#1402 The arrangement of the I/O modules is not consistent with the module table. 16#1407 A communication error occurs when the data is accessed through the auxiliary processor.