Kaiyi — 9.4.5 Intelligent Module Configuration─NTP

Chapter 9 Ethernet Communication Module AH10EN  Input data parameters Users can set an initial data register to which input data is transmitted, and the number of data registers. 12288 data registers at most can be used.  Output data parameters Users can set an initial data register from which data is transmitted, and the number of data registers. 12288 data registers at most can be used. 9.4.5 Intelligent Module Configuration─NTP Users can set the parameters related to time correction.  Correction cycle AH10EN-5A synchronizes the real-time clock in an AH500 series CPU module to a server on a network through the Network Time Protocol (NTP).

To ensure that time is correct, the time is corrected every specific period of time. The default value is 10 minutes. The setting range is from 1 minute to 1440 minutes.  Using Daylight saving time Daylight saving time ─ also summer time ─ is the practice of adjusting clocks forward one hour near the start of spring and adjusted backward in autumn. The total number of hours in a day in spring is 23. Whether a country uses daylight saving time depends on its policy. Since Taiwan does not use DST, the daylight saving time function is not enabled.

 Start date, end date, and time when a one-hour shift occurs After the Daylight Saving Time checkbox is selected, users can set a start date, an end data, and time when a one-hour shift occurs.  NTP server Users can set the IP address of an NTP server. The real-time clock in a CPU module can be synchronized to the NTP server.  Time zone The earth is divided into 24 time zones. Each time zone calculates local time in relation to Greenwich Mean Time (GMT). Users can select the city in which their device is located, or specify the time difference between a local time zone and Coordinated Universal Time (UTC).  Enabling the NTP server service AH10EN-5A can function as an NTP server.

Modules on a network can be synchronized to AH10EN-5A. 9-17