AH500 Module Manual Quality descriptor for events of protection equipment QDP: CP8{ RES, EI, BL, SB, NT, IV} bit 8 7 6 5 4 3 2 1 Refer to section of SEP for more details. Output cirquit information of protection equipment OCI: CP8{ RES, EI, BL, SB, NT, IV} bit 8 7 6 5 4 3 2 1 9.4 Setting AH10/15EN-5A through ISPSoft This section introduces the setting of AH10/15EN-5A through ISPSoft. There are three configurations in ISPSoft. 1. Hardware configuration: Setting the basic parameters 2. Network configuration: Setting the Ether Link 3. Intelligent module configuration:
Setting the exclusive parameters Please refer to ISPSoft User Manual for more information about scanning a module, and opening HWCONFIG and NWCONFIG. 9.4.1 HWCONFIG─Network Parameters All network devices which will be connected to networks need Internet Protocol addresses (IP addresses). The IP addresses are like numbers, and are used to identify the identities of these network devices on the networks. Operation mode Users can select an operation mode of AH10/15EN-5A. They can assign a single IP address to AH10/15EN-5A and make AH10/15EN-5A support a switching hub, or they can assign two IP addresses to AH10/15EN-5A and make the two ports operate individually.
IP address assignment There are two ways to assign IP addresses. Static IP address: An IP address is manually assigned. DHCP: An IP address is assigned by a slave. There must be a slave existing on a local area network. 9-24 IV NT SB BL EI RES RES CL3 CL2 CL1 GC Option Description Static IP address Users assign an IP address, a subnet mask, and a default gateway. DHCP A DHCP slave assigns an IP address, a subnet mask, and a gateway.