AH500 Module Manual 4. Select “Network” >> “Scanner Setting” and then the “Scanner Setting” dialog box pops up. By picking “Master Mode” and “Enable”, the extension baud rate function is started up. Afterwards, select an appropriate baud rate according to the actual demand. Click “OK” after selection is over. Note: If “Slave Mode” is selected, AH10DNET-5A will be set to a slave eventually. 5. Select “Network” >> “Download” and then the following dialog box appears, where click “OK” to download the configuration data to AH10DNET-5A automatically. Note: If “E7” is displayed on AH10DNET-5A, please remove its DeviceNet terminals before downloading. Otherwise, failure to download will occur. 6.
After downloading is completed, turn both of the function switch DR0 and DR1 of AH10DNET-5A to ON and then repower the AH500 series CPU module. At the time, the extension baud rate setting is finished. 10-30