Chapter 10 DeviceNet Communication Module AH10DNET 10.9.3 Configuration of DeviceNet Master 1. Connect the devices following the figure below and remove the RS232 cable from AHCPU530-EN to AHCPU510-EN. 10-49 PS05 viceNet Builder CPU510-EN AH10DNET-5A P S05 C PU510-EN 10DNET RS232 H10DENT-5A on the right of AHCPU510-EN is used as the master and therefo S232 cable must be connected to AHCPU510-EN. SPSoft; select “Tool” >> “Communication Setting” and then the following dialog Select the already built driver and then click “OK”. “File” >> “New” >> “New” and the following dialogue box will appear. Click “OK g the corresponding PLC model.
PS05 CPU510-EN AH10DNET-5A P S05 C PU510 -EN 10DNET CPU51 o AHC nication d then followi 0-EN PU51 Sett click ng di is used as 0-EN. ing” and th “OK”. alogue bo the master and therefo en the following dialog x will appear. Click “OK