Chapter 11 DeviceNet Remote I/O Module AHRTU-DNET 3. Ensure that the baud rates of AH10DNET-5A and AHRTU-DNET-5A are same. 4. Add 24 V network power between V+ and V- and the 120 ohm terminal resistor between CAN_H and CAN_L. 11.5.2 Using DeviceNet Builder to Configure the Network 11.5.2.1 Building and Starting the Communication Channel Driver 1 in COMMGR Open COMMGR and the following interface will appear. Click “Add” button to add a communication channel Driver 1 and set up the channel as follows. 11-59 Module Station address Baud rate AH10DNET-5A 3 500 kbps AHRTU-DNET-5A 1 500 kbps