AH500 Module Manual The communication format and the mapping relations between the AC motor drive and the DVP-SV series PLC are shown below. 11.6.2 AH10SCM-5A Configuration 11.6.2.1 Configuration of AH10SCM-5A Parameters Make the communication and call the DeviceNet Builder software by following the steps introduced in section 5.2.1 and 5.2.2. And the start addresses of AH10DNET-5A for the input and output are D1500 and D1000 respectively. Select the network to be scanned in Project List and then click “Scan DeviceNet Network” button to begin to scan the nodes on the network. If scanning fails, please ensure that the selected master must be AH10DNET-5A in Project List.
11-78 Station Communication Read CPU buffer Write CPU buffer Product address format address register address register 38400, ASCII 16#2000 VFD 10 16#2103 D1540 D1020~D1021 7, E, 1 16#2001 D1550~D1559 D1030~D1034 38400, ASCII D100~D109 D200~D204 PLC 5 Bit 0 in D1560~ Bit 0 in D 1040 7, E, 1 M100~M109 M200~M204 bit 1 in D1561 ~bit 1 in D1040