Kaiyi — 13.9.5 Configuration on the PROFIBUS-DP Network (Software Configuration)

Chapter 13 PROFIBUS Slave Module AH10PFBS  Add AH10PFBS-5A slave and configure the parameters 1. Select the PROFIBUS-DP bus as below; double click AH10PFBS-5A icon in the right column of the following window and a new dialog box appears. 2. Select the node address of AH10PFBS-5A slave from the pull-down menu of “Address” in the following new dialog box. The node address here must be consistent with that set by the address switch of AH10PFBS-5A. Click “OK” after the node address setting is over. 13-31