AH500 Module Manual 14.3.4 Definition of PROFIBUS DP Port Pin 14.3.5 Setting PROFIBUS Node Address via the Rotary Switches The rotary node address switch of AHRTU-PFBS -5A is used for setting the node address of AHRTU-PFBS-5A on the PROFIBUS DP network. The rotary node address switch consists of two rotary switches, x16 0 and x16 1 . The range for either rotary switch is 0 ~ F. The range for setting the node address is as the following table. Example: If you need to set the node address of AHRTU-PFBS-5A to 26 (decimal), simply switch the corresponding switch of x16 1 to “1” and the corresponding switch of x16 0 to “A”. 26 (decimal) = 1A (hex) = 1x16 1 + Ax16 0 . Note:
Switch off the power supply before setting up the node address of AHRTU-PFBS-5A. Re-power the module after the setup is completed. Changing the value on the switch during the operation of AHRTU-PFBS-5A will not be valid immediately until re-powering AHRTU-PFBS-5A after powering it off. Use the slotted screwdriver to set up the switch. Be careful not to scratch the module.
14-6 Pin Definition Description 9 5 6 1 1 -- N/C 2 -- N/C 3 RxD/TxD-P Receiving/Sending data (P (B)) 4 -- N/C 5 DGND Data reference potential (C) 6 VP Power voltage – positive 7 -- N/C 8 RxD/TxD-N Receiving/Sending data (N (A)) 9 -- N/C Address Definition 1 x16 0 x16 H’1 ~ H’7D Valid PROFIBUS address H’0 or H’7E ~ H’FF Invalid PROFIBUS address