Kaiyi — 15.4.3 Assigning Mapping Areas

AH500 Module Manual 15.4.3 Assigning Mapping Areas Users can assign mapping areas to a CANopen master/slave by means of HWCONFIG. AH10COPM-5A functions as a master station. If the start input address set is D5000, and the start output address set is D6000, the mapping areas assigned will be as described below. The data lengths that the users can set must be in the range of 0 words to 480 words. AH10COPM-5A functions as a slave station. The data lengths that the users can set must be in the range of 0 words to 32 words. The relation between the object dictionary in AH10COPM-5A and registers in an AH500 series CPU module is shown below.

Besides, AH10COPM-5A is assigned a two-word normal exchange area. For example, D0~D1 are assigned to AH10COPM-5A. The mapping areas assigned are described below. 15-20 Input area: Slave stationMaster station Output area: Master stationSlave station Register numbers in Register numbers in Data Data an AH500 series CPU Purpose an AH500 series CPU Purpose length length module module D5000~D5479 A CANopen slave station sends data. 0~480 words D6000~D6479 Data is sent to a CANopen slave station.

0~480 words Index Subindex range Input/Output mapping area Access permission H’2000 H’01~H’20 Output mapping area Read/Write H’2001 H’01~H’20 Input mapping area Read-only Register number in an Purpose Data length AH500 series CPU module D0 State of AH10COPM-5A: 0x00: AH10COPM-5A is being initialized. 0x04: AH10COPM-5A stops running. 0x05: AH10COPM-5A is running. 0x7F: AH10COPM-5A is preparing to run. 0x0F: AH10COPM-5A is in an unknown state. 1 word D1 Module error code 1 word