Kaiyi — 15.6.2 Error Codes

AH500 Module Manual  AH10COPM-5A functions as a slave station. 15-38 Code Description Solution 16#A0B0 AH10COPM-5A does not send a heartbeat message after a set period of time. Check whether the bus cable on the CANopen network created is connected correctly. 16#A0B1 The length of a PDO that a slave station sends is not the same as the length of the PDO set in the node list. Set the length of the PDO in the slave station again, and then download the setting to AH10COPM-5A. 16#A0B2 The master station selected does not send a node guarding message after a set period of time. Check whether the bus cable on the CANopen network created is connected correctly. 16#A0F4 The bus used is off.

Please check whether the bus cable on the CANopen network created is connected correctly, make sure that the serial transmission speeds of all the nodes on the network are the same, and power AH10COPM-5A again. 16#A0F5 The node address of AH10COPM-5A is set incorrectly. The node address of AH10COPM-5A must be in the range of 1 to 127. 16#A0F6 Internal error: An error occurs in the manufacturing process in the factory. Power AH10COPM-5A again. If the error still occurs, please replace AH10COPM-5A. 16#A0F7 Internal error: GPIO error 16#A0F8 Hardware error 16#A0F9 Low voltage Make sure that the power supplied to AH10COPM-5A is normal. 16#A0FA An error occurs in the firmware of AH10COPM-5A.

Power AH10COPM-5A again. 16#A0FB The transmission registers in AH10COPM-5A are full. Please make sure that the bus cable on the CANopen network created is connected correctly, and power AH10COPM-5A again. 16#A0FC The reception registers in AH10COPM-5A are full. Please make sure that the bus cable on the CANopen network created is connected correctly, and power AH10COPM-5A again.