Kaiyi — 16.3.1 Installed to Backplanes

Chapter 16 Remote I/O Module AHRTU-ETHN-5A 16.2.3 Ethernet Connector The pins of Ethernet connector are defined in the following table. 16.2.4 IP Address Switch The rotary switch of AHRTUETHN can be used for setting its IP address. The default domain is 192.168.1.x and the range of X is 00~FF. 16.3 Installation of AHRTU-ETHN-5A 16.3.1 Installed to Backplanes AHRTU-ETHN-5A can only be inserted to the CPU slot of AH series main backplane. For details on the installation, see the instructions below. Insert the projection at the bottom of the module to the hole of the backplane and push the module in the direction indicated by the following arrow to meet the CPU port of the backplane.

16-5 5 X1 Ack indicator 6 X2 Link indicator 7 X2 Ack indicator 8 X1/X2 of RJ-45 port 9 MS indicator 10 NS indicator 11 I/O indicator Pin No. Name Description RJ-45 figure 1 TX+ Positive pole for transmitting data 2 TX- Negative pole for transmitting data 3 RX+ Positive pole for receiving data 4 - - 5 - - 6 RX- Negative pole for receiving data 7 - - 8 - - Setting Description value 00 ~ 16#FD 1. Valid IP address: 192.168.1.x, x = 1 ~ FD, (1~253) 2. 16#00: Set through the EIP Builder software. 16#FE Firmware update mode: The IP address will become 192.168.1.3 after connecting AHRTU-ETHN-5A to the network, switching the rotary switch to FE and repowering the module.

For details, refer to Firmware update page of Network configuration in section 16.5.3.4. 16#FF The module will be restored to the factory settings and the settings are not valid until the module is restarted.