Mitsubishi — 5.7 Motion Control Function Block Table

Chapter 5 Applied Instructions 5-129 Model Page Type Name Description 10PM/ 20MC 05PM number 15PM Multiaxial motion control function blocks Setting the parameters of G-code motion Setting the parameters of G-code motion    5-205 Executing G-code motion Setting and executing an Ox motion subroutine    5-207 Stopping G-code motion Stopping the execution of an Ox motion subroutine    5-210 Reading an M-code Reading an M-code    5-212 Multiaxial absolute linear interpolation Starting multiaxial absolute linear interpolation    5-215 Multiaxial relative linear interpolation Starting multiaxial relative linear interpolation    5-217 Stopping multiaxial linear interpolation Stopping multiaxial linear interpolation    5-219 Network function blocks Starting/Stopping a servo drive Starting or stopping the servo drive specified on a DMCNET.

 - - 5-221 Resetting a servo drive Resetting the servo drive specified on a DMCNET  - - 5-222 Writing the value of a parameter into a servo drive Writing the value of a parameter into the servo drive specified on a DMCNET  - - 5-224 Reading the value of a parameter from a servo drive Reading the value of a parameter from the servo drive specified on a DMCNET  - - 5-226 Instructing a servo drive to return home Instructing the servo drive specified on a DMCNET to return home  - - 5-229 Initializing a servo drive Initializing the servo drive specified on a DMCNET  - - 5-232 Instructing a servo drive to capture values Instructing the servo drive specified on a DMCNET to capture values  - - 5-235 Setting an Ethernet IP address Setting the Ethernet IP address of the module used    5-237 Other motion control function blocks Backing a main program up onto an SD card Backing a main program up onto an SD card    5-239 Backing the values in devices up onto an SD card Backing the values in the devices in a module up onto an SD card    5-240 Restoring the values in devices in an SD card Reading the values in the devices specified from the file specified in an SD card    5-242 High-speed counter Starting a high-speed counter    5-244 High-speed timer Starting a high-speed timer    5-246 Setting high-speed comparison Starting high-speed comparison    5-248 Resetting high-speed comparison Resetting high-speed comparison    5-251 Setting high-speed capture Starting high-speed capture    5-252 High-speed masking Starting high-speed masking    5-255 Setting an interrupt Setting the trigger for an interrupt subroutine    5-257 Absolute encoder Starting the reading of the position of an absolute encoder -  - 5-258