Mitsubishi — 5.10.2 Relative Single-speed Motion

Chapter 5 Applied Instructions The number of pulses is a unit for the Distance input pin, and the number of pulses per second is a unit for the Velocity input pin. Users can change the unit used by means of the motion control function block T_AxisSetting2. 3. Troubleshooting 5-143 Output pin Name Function Data type Time when there is Time when there is a transition in an output pin’s signal from high to low a transition in an output pin’s signal from low to high Busy The motion control function block is being executed. BOOL  There is a transition in the Busy output pin’s signal from low to high when there is a transition in the Execute input pin’s signal from low to high.

 There is a transition in the Busy output pin’s signal from high to low when there is a transition in the Done output pin’s signal from low to high.  There is a transition in the Busy output pin’s signal from high to low when there is a transition in the Error output pin’s signal from low to high.  There is a transition in the Busy output pin’s signal from high to low when there is a transition in the Aborted output pin’s signal from low to high. Aborted The execution of the motion control function block is interrupted by a command. BOOL  The execution of the motion control function block is interrupted by a command.

 There is a transition in the Aborted output pin’s signal from high to low when there is a transition in the Execute input pin’s signal from high to low.  If the Execute input pin is set to False when the execution of the motion control function block is interrupted, the Aborted output pin will be set to False in the next cycle. Error An error occurs in the motion control function block. BOOL  Input values are incorrect.  The axis specified is in motion before the motion control function block is executed.  There is a transition in the Error output pin’s signal from high to low when there is a transition in the Execute input pin’s signal from high to low.

Error Troubleshooting The values of input pins in the motion control function block are incorrect. Check whether the values of the input pins are in the ranges allowed.