Chapter 5 Applied Instructions 5-175 Input pin Name Function Data Setting value Time when a value is valid type Vmax Maximum speed DWORD K1~K2,147,483,647 The value of the Vmax input pin is valid when there is a transition in the Execute input pin’s signal from low tot high. Vbias Start-up speed DWORD K0~K2,147,483,647 The value of the Vbias input pin is valid when there is a transition in the Execute input pin’s signal from low to high. Tacc Acceleration time (Unit: ms) WORD K0~K32,767 The value of the Tacc input pin is valid when there is a transition in the Execute input pin’s signal from low to high. Tdec Deceleration time (Unit:
ms) WORD K0~K32,767 The value of the Tdec input pin is valid when there is a transition in the Execute input pin’s signal from low to high. State of output pin Name Function Data type Time when there is Time when there is a transition in an output pin’s signal from high to low a transition in an output pin’s signal from low to high Done The execution of the motion control function block is complete. BOOL There is a transition in the Done output pin’s signal from low to high when the writing of parameters is complete. There is a transition in the Done output pin’s signal from high to low when there is a transition in the Execute input pin’s signal from high to low.
If the Execute input pin is set to False when the execution of the motion control function block is complete, the Done output pin will be set to False in the next cycle.