Chapter 5 Applied Instructions 5.11.2 Executing G-code Motion 1. Motion control function block The motion control function block T_GcodeRun is used to set and execute an Ox motion subroutine. The value of the OxNum indicates an Ox motion subroutine number. 2. Input pins/Output pins 5-207 Input pin Name Function Data Setting value Time when a value is valid type OxNum Ox motion subroutine number WORD OX0~OX99: 0~99 SD card: 100~199 The value of the OxNum input pin is valid when there is a transition in the Execute input pin’s signal from low to high. Execute An Ox motion subroutine is executed when there is a transition in the Execute input pin’s signal from low to high.
BOOL True/False - State of output pin Name Function Data type Time when there is Time when there is a transition in an output pin’s signal from high to low a transition in an output pin’s signal from low to high Done The execution of the function block is complete. BOOL There is a transition in the Done output pin’s signal when the execution of an Ox motion subroutine is complete. There is a transition in the Done output pin’s signal from high to low when there is a transition in the Execute input pin’s signal from high to low. If the Execute input pin is set to False when motion is complete, the Done output pin will be set to False in the next cycle.