AH500 Motion Control Module Manual FB2 indicates a parameter number, and the value of the Value input pin in the motion control function block named FB2 indicates the value written into the servo drive specified. Steps: (a) Reset the servo drive specified by means of the motion control function block named FB1. (b) After the servo drive specified is reset, the motion control function block named FB2 will be executed automatically. (c) After the execution of the motion control function block name FB2 is complete, Done1 will be set to True. Timing diagram: 5. Modules which are supported The motion control function block T_DMCServoWrite supports AH20MC-5A.
5.12.4 Reading the Value of a Parameter from a Servo Drive 1. Motion control function block The motion control function block T_DMCServoRead is used to read the value of a parameter from the servo drive specified on a DMCNET. The value of the Axis input pin indicates an axis number, the value of the Group input pin indicates a group number, the value of the Parameter input pin indicates a parameter number, and the value of the Value input pin indicates the value read from the servo drive specified. 5-226