AH500 Motion Control Module Manual (c) ModeNum determines the mode of returning home. Timing diagram: 5. Modules which are supported The motion control function block T_DMCServoHoming supports AH20MC-5A. 5.12.6 Initializing a Servo Drive 1. Motion control function block The motion control function block T_DMCControllnit is used to initialize the servo drive specified on a DMCNET. The value of the Axis input pin indicates an axis number. The value of the DMC-RatioNum is the numerator of an electronic gear ratio. The value of the DMC-RatioDen is the denominator of an electronic gear ratio. 2.
Input pins/Output pins 5-232 Input pin Name Function Data Setting value Time when a value is valid type Axis Motion axis number WORD 1~12 The value of the Axis input pin is valid when there is a transition in the Execute input pin’s signal from low to high.