AH500 Motion Control Module Manual 3. Troubleshooting 4. Example Purpose: The motion control function block T_DMCControllnit is used to initialize the servo drive specified on a DMCNET, and set an electronic gear ratio. The motion control function block T_DMCControllnit can be used to set an electronic gear ratio. After the execution of the motion control function block T_DMCControllnit is complete, a uniaxial motion control function block or a multiaxial motion control function block can be used to start motion of the servo drive specified. 5. Modules which are supported The motion control function block T_DMCControllnit supports AH20MC-5A. 5-234 low to high.
State of output pin Name Function Data type Time when there is Time when there is a transition in an output pin’s signal from high to low a transition in an output pin’s signal from low to high Error An error occurs in the motion control function block. BOOL Input values are incorrect. There is a transition in the Error output pin’s signal from high to low when there is a transition in the Execute input pin’s signal from high to low. Error Troubleshooting The values of input pins in the motion control function block are incorrect. Check whether the values of the input pins are in the ranges allowed.