Mitsubishi — 5.13.2 Backing the Values in Devices up onto an SD Card

AH500 Motion Control Module Manual 3. Troubleshooting 4. Modules which are supported The motion control function block T_SDProgWrite supports AH10PM-5A, AH15PM, and AH20MC-5A. 5.13.2 Backing the Values in Devices up onto an SD Card 1. Motion control function block The motion control function block T_SDDevWrite is used to back the values in the devices in a module up onto an SD card. The value of the FileName input pin indicates a filename.

5-240 State of output pin Name Function Data type Time when there is Time when there is a transition in an output pin’s signal from high to low a transition in an output pin’s signal from low to high Busy The motion control function block is being executed. BOOL  There is a transition in the Busy output pin’s signal from low to high when there is a transition in the Execute input pin’s signal from low to high.  There is a transition in the Busy output pin’s signal from high to low when there is a transition in the Error output pin’s signal from low to high.

 There is a transition in the Busy output pin’s signal from high to low when there is a transition in the Done output pin’s signal from low to high. Error An error occurs in the motion control function block. BOOL  Input values are incorrect.  There is a transition in the Error output pin’s signal from high to low when there is a transition in the Execute input pin’s signal from high to low. Error Troubleshooting The values of input pins in the motion control function block are incorrect. Check whether the values of the input pins are in the ranges allowed.