Mitsubishi — 7.1 Functions of Uniaxial Motion

AH500 Motion Control Module Manual 7.1 Functions of Uniaxial Motion The special data registers for motion axes are described below 7-2 SR number Factory (1+N)th axis*4 Function Setting range setting HW*1 LW*1 - SR1000+100*N Setting the parameters of the axis specified Bit 0~bit 15 16#0 - SR1001+100*N Compensation value for the axis specified Users can set SR1001+100*N according to their needs.

16#0 SR1003+100*N SR1002+100*N Number of pulses it takes for the motor of the axis specified to rotate once (A) 1~2,147,483,647 pulses/revolution K2,000 SR1005+100*N SR1004+100*N Distance generated after the motor of the axis specified rotate once (B) 1~2,147,483,647*2 K1,000 SR1007+100*N SR1006+100*N Maximum speed (V ) at MAX which the axis specified rotates 0~2,147,483,647*3 K10,500,000 SR1009+100*N SR1008+100*N Start-up speed (V ) at which BIAS the axis specified rotates 0~2,147,483,647*3 K0 SR1011+100*N SR1010+100*N JOG speed (V ) at which JOG the axis specified rotates 0~2,147,483,647*3 K5,000 SR1013+100*N SR1012+100*N Speed (V ) at RT which the axis specified returns home 0~2,147,483,647*3 K50,000 SR1015+100*N SR1014+100*N Speed (V ) to CR which the speed of the axis specified decreases when the axis returns home 0~2,147,483,647*3 K1,000 - SR1016+100*N Number of PG0 pulses for the axis specified 0~32,767 pulses K0 - SR1017+100*N Supplementary pulses for the axis specified -32,768~+32,767 pulses K0