Mitsubishi — 11.2 Comparison

AH500 Motion Control Module Manual 11.1 Format of an Instruction An AH500 series motion control module sets and reads values by means of the instructions FROM and TO. The use of FROM/TO to set high-speed comparison and high-speed capture, and to read values is described below.

 Control X0.0 Module number Control register number Initial device number Number of values  Reading X0.0 Module number Control register number Initial device number Number of values 11.2 Comparison  Control X0.0 Module number Control register number Initial device number Number of values  Definitions 11-2 .0 TO K253 K1 S N FROM K253 K1 S N .0 TO K253 K1 S N Device Control S Initial group number n (n=0~7) S +1 0 (S , S ) +3 +2 Control registers whose group number is n (S , S ) +5 +4 Data registers whose group number is n (S , S ) +7 +6 Control registers whose group number is n+1 (S , S ) +9 +8 Data registers whose group number is n+1 : :

(S , S ) +31 +30 Control registers whose group number is n+7 (S , S ) +33 +32 Data registers whose group number is n+7 S +50 Number of devices=2+m*4 m=Number of groups (8 groups at most can be used.)