Mitsubishi — 12.6 Troubleshooting

Chapter 12 Setting an Ethernet Network 12.6 Troubleshooting 12-7 Problem Remedy The Ethernet connection LED indicator on an AH500 series motion control module is not ON. Check whether a networking cable is connected to the AH500 series motion control module correctly. An AH500 series motion can not be connected to PMSoft. Check whether the IP address of the AH500 series motion control module is correct. If the IP address of the AH500 series motion control module and the IP address of the driver created are not in the same domain, the AH500 series motion can not be connected to PMSoft. A Modbus TCP connection can not be created. 1.

Check whether the setting of the IP address of the server to which a client is connected is correct. The number of Modbus TCP connections can not be greater than 12. 2. Check whether the setting of a station address is correct. If users do not know the station address of the AH500 series motion control module which is connected, they can set the station address to 0.