Chapter 14 DMCNET 14.8 Troubleshooting 14-19 Problem Remedy The DMCNET connection LED indicator on an AH500 series motion control module is not ON. Check whether a networking cable is connected to the AH500 series motion control module correctly, and check whether a terminal resistor is connected correctly. The value of bit 0~bit 3 in SR1073 (SR1173, SR1273…) is 0. Users have to instruct the servo drive used to reset NMT by means of bit 0~bit 3 in SR1072 (SR1172, SR1272…). If the servo drive is still not connected, the users have to check whether the cables connected to the hardware used are loose, and check whether a terminal resistor is connected.
The value of a parameter in a servo drive is incorrect. Check whether the parameter can be set when the servo is ON/OFF, and check whether the data type set is correct. After a value is written into a servo drive, no response is received in a specified amount of time. Check whether the servo drive can be connected correctly. After P0-02 in a servo drive is set to 16#120, the value shown on the display of the servo drive is 16#06. 1. Check whether there is a servo drive whose node ID is 1 on the DMCNET created. 2. Check whether the cables connected to the hardware used are loose.