Mitsubishi — A.1 Error Code Tables

Appendix A Error Code Table  If a servo drive is connected successfully, the error codes stored in the error registers in AH20MC-5A will include servo drive error codes. The servo drive error code stored in an error register in AH20MC -5A is composed of an AL code and 16#8000. Please refer to Chapter 10 in ASDA-A2 Series User Manual for more information about the servo drive error codes which are not described in the table below. A-3 Error code Error Description Description code 0024 The velocity (V ) to which the CR velocity of the axis specified decreases when the axis returns home is incorrect. C4FF A wrong instruction is used, or a device used exceeds the range available.

0025 The JOG speed set is incorrect. 8000 A DMCNET servo drive is disconnected. (AH20MC-5A supports DMCNET communication.) Error Error Description Description code code 8001 Overcurrent 8014 Reverse limit switch error 8002 Overvoltage 8015 Forward limit switch error 8003 Undervoltage 8016 An IGBT overheats. 8004 Motor error 8018 Encoder output error 8005 Regeneration error 8030 Motor protection error 8006 Overload 8301 DMCNET synchronization fails. 8007 Overspeed 8302 DMCNET synchronization signal error 8009 Excessive deviation 8303 DMCNET synchronization timeout 8011 Encoder error 8012 Adjustment error 8013 A servo drive makes an emergency stop.