Delta Electronics AH500 — 3.1.1 Installing ISPSoft

AH500 Operation Manual Before developing an AH500 system, users need to install ISPSoft and COMMGR, which are basic software. ISPSoft is a platform for integrating the program development of a whole system, hardware configuration, and network configuration. COMMGR functions as middleware between a computer and devices. For example, it functions as a communication management interface between ISPSoft and AH500 series hardware. 3.1 Installing and Uninstalling ISPSoft  System requirements *1. ISPSoft supports several ways in which a computer is connected to a PLC. Users have to make sure of the port and the mode supported by a PLC before a computer is connected to the PLC. *2.

Please refer to section 1.2 for more information about COMMGR. *3. In addition to ISPSoft, users must use PMSoft version 2.05 or above to develop AH10PM-5A and AH20MC-5A. *4. The functions and specifications mentioned above are only applicable to ISPSoft version 2.00 or above. The older versions are not equipped with the complete functions. 3.1.1 Installing ISPSoft If an older version of ISPSoft has been installed on a computer, users have to uninstall it before install ISPSoft. Pleases refer to section 3.1.2 for more information about uninstalling ISPSoft. The following are the steps of installing ISPSoft. (1) Start the Windows 2000/NT/Me/XP/Vista/7 operating system.

(2) Put the ISPSoft CD in the CD-ROM drive, or download the installation program from http://www.delta.com.tw/ch/index.asp. (Before the installation program downloaded from the website is installed, it has to be decompressed.) 3-2 Item System requirement Operating system Windows 2000/NT/Me/XP/Vista/7 CPU Pentium 1.5 G or above Memory 256 MB or above (A memory having a capacity of 512 MB or above is recommended.) Hard disk drive Capacity : 500 MB or above CD-ROM drive For installing ISPSoft It is optionally required. Monitor Resolution: 800×600 or above (Setting which is suggested:

1024x768/96 dpi) Keyboard/Mouse A general keyboard/mouse, or devices compatible with Windows Printer A printer with a driver for Windows (It is used to print a project, and is optionally required.) RS-232 port For connecting to a PLC One of them is used, but a PLC which is connected must have a corresponding port. (*1) USB port For connecting to a PLC Ethernet port For connecting to a PLC Communication COMMGR, a communication manager, must be installed on a computer. (*2) software Models which are supported AH500 series PLCs/DVP series PLCs (exclusive of DVP-PM series PLCs)/VFD-C2000 series AC motor drives/VFD-C200 series AC motor drives/VFD-CP2000 AC motor drives /VFD-E AC motor drives (*3)