AH500 Operation Manual 4.1.2 Installing a Module Prepare modules which will be used, e.g. a power supply module, a CPU module, and digital I/O modules, and etc. Please follow the steps of installing a module illustrated in chapter 2 in AH500 Hardware Manual. Insert a module into a slot, make sure that the module is installed on the backplane properly, and tighen the the screw, as illustrated below. 1. Insert the projection under the module into the hole in the backplane. 2. Push the module in the direction indicated by the arrow until it clicks. 3. Tighten the screw on the module. 4-4