AH500 Operation Manual The system automatically assigns devices to a module which is added. If the devices assigned to a module do no conform to what is expected, users can click the Input/Output Device Range cell for the module, click in the cell, and type a device address in the Manual Assignment window. 6.4.2 Setting the Parameters in a CPU Module and a Module After AH16AP11R-5A is configured, users can set the parameters in the CPU module and the parameters in the extension module. After the users double-click the CPU module or the extension module, a corresponding window will appear. After the CPU module is double-clicked, the PLC Parameter Setting window will appear.
The users can click the primary tabs at the top of the window, and the secondary tables at the bottom of the window to set the parameters. In this example, the users only need to define the name of the CPU module. After the users click the CPU tab at the top of the window, and the Name tab at the bottom of the window, they can type a name in the Name box. The users will find the default name in the Name box is the same as the project name. Delete the default name, type “Main_Controller” in the Name box, and click OK . 6-6