Delta Electronics AH500 — 6.5.8 Basic Editing─Creating a Comparison Contact and Typing a Constant

Chapter 6 Writing a Program After the instruction is inserted successfully, the users can assign a device address to the operand, and write the program shown below. 6.5.8 Basic Editing─Creating a Comparison Contact and Typing a Constant A comparison contact can be inserted not only in one of the three ways described in section 6.5.7, but also by means of the following steps. Users need to put network 7 under network 6, and write the program shown below. (1) Click on the toolbar, and then select a type (>= in this example). (2) Click on the toolbar, and then move the mouse cursor to the position where the comparison contact will be inserted.

The mouse cursor appears as a comparison contact when the mosue is moved to the left side of the red frame, the right side of the red frame, or the bottom of the red frame. The users can decide where to insert the comparison contact. After the users decided on a position, they can click the left mouse button to insert the comparison contact. 6-21