Chapter 6 Writing a Program Type a driver name in the Driver Name box. Select USB (Virtual COM ) in the Type drop-down list box in the Connection Setup section. Select a communication port in the COM Port drop-down list box. If the first two steps are complete, the PLC which is connected and its communication port will be displayed in the COM Port drop-down list box. Users can select the number of times the sending of a command is retried if a connection error occurs in the Time of Auto-retry box, and select an interval of retrying the sending of a command in the Time Interval of Auto-retry box. (6) Click the driver created in the COMMGR window, and then click Start .
Start ISPSoft, and then click Communication Settings… on the Tools menu. In the Communication Setting window, select the driver which has been created in the Driver drop-down list box, appear, and select 0 in the Station Address drop-down list box, and click OK . The information about the driver will be displayed in the status bar in ISPSoft. (7) Click System Information on the PLC menu. ISPSoft will retrieve related information from the PLC. If the computer communicates with the CPU module normally, the related information retrieved from the PLC will be displayed in the System Information window. 6-25