Chapter 8 Hardware Configuration the users can access the module through the data registers. Accessing a module through the data registers is more efficient than accessing the module through the instruction FROM/TO. As the example below shows, D3000 corresponds to the parameter CH0 Average Time in the Parameter Setting window for AH04AD-5A. After the parameters in HWCONFIG are downloaded to the CPU module, users can change the value of the parameter CH0 Average Time by changing the value in D3000 in the CPU module.
Besides, if users write a value which is not allowed by a parameter into a data register during the operation of the system, the system will restore the value in the data register and the value of the parameter to the original values. *. Please refer to section 8.3 for more information about the setting of parameters in a module. Please refer to programming manuals for more information about the instruction FROM/TO. The Input/Output Device Range column on the information list can be defined not only by the system, but also by users. Users can click a cell on the information list, and then click , or type a start address directly.
After the Manual Assignment window appears, the users can type a start address, and click OK . 8-10