AH500 Operation Manual Method 2 Click the blank or a present rack in the system configuration area, and then click Paste on the Edit menu, or on the toolbar. Additional remark When an extension rack is cut/pasted, the parameters in the modules on the extension rack are processed as follows. Input/Output device range : The input/output devices assigned to the modules on the extension rack cut are automatically assigned to the modules on the extension rack pasted. Comments about the modules : The comments about the modules on the extension rack cut are copied into the modules on the extension rack pasted. Parameters in the modules :
The parameters in the modules on the extension rack cut are copied into the modules on the extension rack pasted. Data registers : The data registers assigned to the modules on the extension rack cut are automatically assigned to the modules on the extension rack pasted. Parameters in the intelligent modules : The setting of the parameters in the intelligent modules is copied. When an extension rack is copied/pasted, the parameters in the modules on the extension rack are processed as follows. Input/Output device range :
The input/output device addresses assigned to the modules on the extension rack pasted follow the input/output device addresses assigned to the modules on the extension rack copied. Comments about the modules : The comments about the modules on the extension rack copied are copied into the modules on the extension rack pasted. Parameters in the modules : The parameters in the modules on the extension rack cut are copied into the modules on the extension rack pasted. Data registers : The data register addresses assigned to the modules on the extension rack pasted follows the data registers addresses assigned to the modules on the extension rack copied.
Parameters in the intelligent modules : The setting of the parameters in the intelligent modules is not copied, and is restored to the default values. *. Some intelligent modules can be set by means of exclusive configuration tools. Please refer to section 8.3.4 for more information. 8-27