AH500 Operation Manual 8.2.2.2 CPU: System After users click the CPU tab at the top of the window, and the System tab at the bottom of the window, they can set the parameters in the CPU module. Clear Non-latched Device (STOP RUN) If the Enable checkbox is selected, the states of the non-latched devices, and the values in the non-latched devices are cleared when the CPU module begins to run. Y state (STOP RUN) When the CPU module begins to run, the states of the Y devices are OFF, retained, or restored to the states before the CPU module’s stopping running. Clear : All Y devices are set to OFF. Retain Present State : The states of the Y devices are retained.
Previous State before STOP : The states of the Y devices are restored to the states before the CPU module’s stopping running. Reset Button & Clear Button Whether the RST button and CLR button on the CPU module is enabled or disabled depends on the setting of these parameters. Please refer to an operation manual for more information about the functions of the buttons. 8-31