Chapter 9 Network Configuration After the users click Print Preview on the File menu, or on the toolbar, the system will automatically open the Print Preview window, and the network framework that the users create in NWCONFIG will be displayed in the Print Preview window. Please refer to appendix C for more information. Before the users print the data related to a PLC Link or an Ether Link, they have to export the data as a CSV file. After the CSV file is opened in Microsoft Excel, they can print the data in the CSV file.
9.3.2 Downloading Parameters In the working area in NWCONFIG, users can download the routing tables produced to PLCs, the parameters related to the PLC Links constructed, and the parameters related to the Ether Links constructed to the nodes. The users have to download the routing tables produced to nodes in the working area. 9.3.2.1 Introduction of Parameters Routing table The routing data stored in a PLC is data related to the PLC itself, and therefore the routing tables downloaded to nodes are different. Parameters related to a PLC Link The parameters related to a PLC Link can only be downloaded to the PLC designated as a master station.
If the parameters related to a PLC Link are downloaded to a slave station, the related special relays and the related special registers in the slave station will be restored to the default setting. There is only one master station in a network. If users are not sure whether a device was designated as a master station, and whether the parameters related to a PLC Link was downloaded to the device, they have to download the parameters related to a PLC Link to the device. Parameters related to an Ether Link The parameters related to an Ether Link must be downloaded to the data demanding nodes. However, the data exchange table stored in a PLC is a table related to the PLC itself.
Besides, if the parameters set include a node which does not demand any data, the data in the node will be cleared after the parameter are downloaded to the node, and the start mode of the node will depend on the parameters after the 9-37