Delta Electronics AH500 — 11.2.2.5 Start Mode of an Ether Link

Chapter 11 Convenient Functions and set the other cells. 11.2.2.5 Start Mode of an Ether Link There are three start modes. Please refer to the table below for more information. Ether Links. The execution of an Ether Link is based on the nodes in a network. If some of the ports that a node has are connected to a network, users can set the start modes of the ports separately. When the Ether Link constructed is executed, the system automatically distributes reading/writing work to the ports according to the start modes of the ports. If a port is disconnected, the system will pass the work belonging to the port to another port. *.

Please refer to manuals or technical documents for more information about special auxiliary relays related to 11-43 Start mode Description Always Stop During the operation of the PLC, no data exchange is performed. Always Run When the PLC runs, data exchange is performed. SM Flag The performance of data exchange depends on a special auxiliary relay in the PLC. After users select SM Flag, they can set the initial state of the related special auxiliary relay.