AH500 Operation Manual Points for attention: After the setting of the function switch of AH10DNET-5A is changed, users have to power AH10DNET-5A again, otherwise the change will not take effect. Please use a slotted screwdriver to adjust the DIP switch with care, and do not scrape them. 3. DeviceNet connector 1 2 3 4 5 AH10PFBM-5A 1 2 6 5 8 7 3 CON F 9 4 Profibus 10 2-61 DR 1 DR 0 Transmission speed OFF OFF 125 kbps OFF ON ON OFF 250 kbps 500 kbps ON ON Entering the extendable serial transmission speed mode IN 1 Reserved If the slave is disconnected, the previous ON I/O data is retained. If the slave is disconnected, the previous OFF I/O data is cleared.
IN 0 If the slave is disconnected, the previous I/O data is cleared. Pin Signal Color Description 5 4 V+ CAN H _ Red White 24 V DC Signal (positive pole) It is connected to a 3 2 1 SHIELD CAN L _ V- - Blue Black shielded cable. Signal (negative pole) 0 V DC Number Name Description 1 Model name Model name of the module 2 3 Seven-segment display CONF interface Display The interface where the hardware configurati on is downloaded 4 PROFIBUS-DP interface PROFIBUS-DP connection 5 RUN LED indicator LED indicator 6 SYS LED indicator LED indicator 7 DP LED indicator LED indicator