AH500 Programming Manual Output instructions Master control instructions Rising-edge/Falling-edge detection contact instructions Rising-edge/Falling-edge output instructions 3-8 Instruction Execution Symbol Function Operand code condition OUT Driving the coil DY, X, Y, M, S, T, C, HC, D, L, SM, and PR SET Keeping the device on DY, X, Y, M, S, T, C, HC, D, L, SM, and PR Instruction Symbol Function Operand code MC Setting the master control N MCR Resetting the master control N Instruction Execution Symbol Function Operand code condition LDP Starting the rising-edge detection/Connecting the rising-edge detection in series/Connecting the rising-edge detection in parallel DX, X, Y, M, S, T, C, HC, D, L, SM, and PR PED ANDP APED ORP OPED LDF Starting the falling-edge detection/Connecting the falling-edge detection in series/Connecting the falling-edge detection in parallel DX, X, Y, M, S, T, C, HC, D, W, L, SM, and PR NED ANDF ANED ORF ONED Instruction Execution Symbol Function Operand code condition PLS Rising-edge output DY, X, Y, M, S, T, C, HC, D, L, SM, and PR