Chapter 7 Error Codes 7-5 Error code Description CPU Status LED indicator status ERROR BUS FAULT 16#140C The checksum of the high-speed data exchange is incorrect. (SM9) Stop Keep ON 16#140D The ID of the actual power supply module is not the same as the ID of the power supply module set in HWCONFIG. (SM9) Stop Keep ON 16#140E The amount of data exchanged at a high speed exceeds the maximum amount supported. (SM10) Stop Keep ON 16#140F High-speed data exchange error (SM11) Stop Keep ON 16#1801 There is no interrupt service routine in the CPU module. Continue Keep Keep 16#2000 There is no END in the program in the PLC. (SM5) Stop Blinking Keep 16#2001 The program is incorrect.
There is a syntax error. (SM5) Stop Blinking Keep 16#2002 GOEND is used incorrectly. (SM5) Stop Blinking Keep 16#2003 The devices used in the program exceed the range. (SM0/SM5) Self-defined Blinking Keep 16#2004 The part of the program specified by the label used in CJ/JMP is incorrect, or the label is used repeatedly. (SM0/SM5) Stop Blinking Keep 16#2005 The N value used in MC is not the same as the corresponding N value used in MCR, or the number of N values used in MC is not the same as the number of N values used in MCR. (SM5) Stop Blinking Keep 16#2006 The N values used in MC do not start from 0, or the N values used in MC are not continuous.
(SM5) Stop Blinking Keep 16#2007 The operands used in ZRST are not used properly. (SM5) Stop Blinking Keep 16#200A Invalid instruction (SM5) Stop Blinking Keep 16#200B The operand n or the other constant operands exceed the range. (SM0/SM5) Self-defined Blinking Keep 16#200C The operands overlap. (SM0/SM5) Self-defined Blinking Keep 16#200D An error occurs when the binary number is converted into the binary-coded decimal number. (SM0/SM5) Self-defined Blinking Keep 16#200E The string does not end with 0x00. (SM0/SM5) Self-defined Blinking Keep 16#200F The instruction does not support the modification by an index register. (SM5) Stop Blinking Keep 16#2010 1.
The instruction does not support the device. 2. Encoding error 3. The instruction is a 16-bit instruction, but the constant operand is a 32-bit code. (SM5) Stop Blinking Keep 16#2011 The number of operands is incorrect. (SM5) Stop Blinking Keep 16#2012 Incorrect division operation (SM0/SM5). Self-defined Blinking Keep 16#2013 The value exceeds the range of values which can be represented by the floating-point numbers. (SM0/SM5) Self-defined Blinking Keep