AH500 Programming Manual 7.1.6 AH10EN-5A 7-24 Error code Description LED indicator status CPU Module BUS ERROR FAULT 16#A009 The pointer used in JMP is the same as the pointer used in CALL. Blinking 16#A00B Target position (I) of the single speed is incorrect. Blinking 16#A00C Target position (II) of the single-axis motion is incorrect. Blinking 16#A00D The setting of speed (I) of the single-axis motion is incorrect. Blinking 16#A00E The setting of speed (II) of the single-axis motion is incorrect. Blinking 16#A00F The setting of the speed (V ) of returning to zero is RT incorrect. Blinking 16#A010 The setting of the deceleration (V ) of returning to CR zero is incorrect.
Blinking 16#A011 The setting of the JOG speed is incorrect. Blinking 16#A012 The positive pulses generated by the single-axis clockwise motion are inhibited. Blinking 16#A013 The negative pulses generated by the single-axis counterclockwise motion are inhibited. Blinking 16#A014 The limit switch is reached. Blinking 16#A015 The device which is used exceeds the device range. Blinking 16#A017 An error occurs when the device is modified by a 16-bit index register/32-bit index register. Blinking 16#A018 The conversion into the floating-point number is incorrect. Blinking 16#A019 The conversion into the binary-coded decimal number is incorrect.
Blinking 16#A01A Incorrect division operation (The divisor is 0.) Blinking 16#A01B General program error Blinking 16#A01C LD/LDI has been used more than nine times. Blinking 16#A01D There is more than one level of nested program structure supported by RPT/RPE. Blinking 16#A01E SRET is used between RPT and RPE. Blinking 16#A01F Incorrect division operation (The divisor is 0.) Blinking 16#A020 The wrong instruction is used, or the device used exceeds the range. Blinking Error code Description LED indicator status CPU Module BUS Error FAULT 16#A001 The IP address of host 1 conflicts with another system on the network.
Blinking 16#A002 The IP address of host 2 conflicts with another system on the network. Blinking 16#A003 DHCP for host 1 fails. Blinking 16#A004 DHCP for host 2 fails. Blinking 16#A401 Hardware error ON 16#A402 The initialization of the system fails. ON