cisco Catalyst 9300 — Feature History for Layer 3 Subinterfaces

Example: Configuring Layer 3 Subinterfaces The following example shows how to configure subinterfaces on layer 3 interfaces: Device> enable Device# configure terminal Device(config)# interface HundredGigabitEthernet 1/0/33 Device(config-if)# no switchport Device(config-if)# no ip address Device(config-if)# exit Device(config)# interface HundredGigabitEthernet 1/0/33.201 Device(config-subif)# encapsulation dot1q 201 native Device(config-subif)# end The following example shows how to configure subinterfaces on layer 3 port channels:

Device> enable Device# configure terminal Device(config)# interface port-channel 2 Device(config-if)# no switchport Device(config-if)# no ip address Device(config-if)# exit Device(config)# interface port-channel 2.10 Device(config-subif)# encapsulation dot1q 10 Decvice(config-subif)# ip address 10.10.10.11 255.255.255.0 Device(config-subif)# end Feature History for Layer 3 Subinterfaces This table provides release and related information for the features explained in this module. These features are available in all the releases subsequent to the one they were introduced in, unless noted otherwise. Configuring Layer 3 Subinterfaces Example:

Configuring Layer 3 Subinterfaces Command or Action Purpose traffic passing through the parent interface or other subinterfaces. Step 5 end Example: Device(config-subif)# end Exits subinterface mode and returns to privileged EXEC mode. VLAN Configuration Guide, Cisco IOS XE 17.16.x (Catalyst 9300 Switches) 102