cisco Catalyst 9300 — Information About Wired Dynamic PVLAN

C H A P T E R 7 Configuring Wired Dynamic PVLAN The following sections provide information about configuring wired dynamic PVLAN: Restrictions for Wired Dynamic PVLAN, on page 105 Information About Wired Dynamic PVLAN, on page 105 Configuring Wired Dynamic PVLAN, on page 107 Feature History for Wired Dynamic PVLAN, on page 112 Restrictions for Wired Dynamic PVLAN • High availability is not supported with Wired Dynamic PVLAN. • Voice VLAN configuration cannot co-exist with this feature. • Local Web Authentication (LWA) and Central Web Authentication (CWA) cannot be used with this feature. • All wired clients using the dynamic PVLAN interface template will be programmed as data clients.

• Only interfaces with existing Access or PVLAN Host switchport mode support PVLAN template. • Identity Based Networking Services 2.0 (IBNS 2.0) must be used for dynamic template support. Information About Wired Dynamic PVLAN Wired Dynamic PVLAN is a feature that uses a private VLAN with AAA authorization to isolate clients and provide Zero-Trust. It is a method to block peer to peer communications within a subnet/VLAN. Here, the client is assigned to a PVLAN which isolates a wired client connected on one port from all other ports on Layer 2 while the Layer 3 communication occurs via the promiscuous port.

In this feature, a single wired data client is supported per port interface, to ensure point-to-point blocking. Traffic from multiple clients on the same interface will not be blocked. Note VLAN Configuration Guide, Cisco IOS XE 17.16.x (Catalyst 9300 Switches) 105